This cartridge is totally obsolete. Unless you are serious about spending a lot of money to find one, we might suggest replacing the entire turntable that uses "normal" cartridges. B&O made a proprietary mounting system for their cartridges to fit in their tonearms. Also when the needle goes bad you have to replace the entire cartridge for 100's of dollars.
Please Note: Yes we know the pic is of the mmc4, we felt it more important for one more customer to get a factory sealed cartridge rather than getting a pic with a 2 on it.
They are B&O factory sealed! The MMC2 is a function replacement for the MMC1 MMC3 MMC4 and MMC5 (MMC1 is top of the line, MMC5 is bottom.) The needle on your existing cartridge is not user replaceable. Keep your old one in case we ever find a good tip replacement service.
This wonderful cartridge will work in any of the following Bang & Olufsen models:
Stylus: Contact Line .12x.12mm square Nude Natural Diamond tip
Radius of Curvature: "Contact Line"
Cantilever: Sapphire Tube
Effective Tip Mass: 0.3 mg
Compliance: 30 m/mN
Tracking Force: 1.0 grams/10mN
Output Voltage Level: 2.12mV @ 5cm/sec. Lat. RMS
Cartridge Weight: 1.6grams
Frequency Response: 20 - 20Khz
Channel Separation @ 1kHz: 25 dB
Channel Separation @ 50-15kHz: 20 dB
Channel Difference: <1.5 dB
Load Impedance: 47K ohm
Load Capacitance: >/= 47kohms
Channel Balance: 1.5 dB