The round cross section is .139 Inch / 3.5mm Thick.
The inside Circumference is 12.8 Inches /32.5 cm
This belt is found in, but NOT necessarily limited to, the following Equipment:
AIRLINE (Wards) GTL-3829A B
AIRLINE (Wards) S-5000
AMPEX AG-500 (AG Series) (2 Belts)
AMPEX AG-600 (AG Series)
AMPEX AG-5150 AG Series
AMPEX AG-5224 AG Series
AMPEX AX-50 (Non-series)
AMPEX S-5098 (AG Series)
BELL and HOWELL 2423
BELL and HOWELL 2433
CONCORD MK-III (MARK 3)
CONCORD MK-VIII (MARK 8)
FEDERAL TRANSISTOR 37-B
Meets or exceeds OEM specs. Found in many types of equipment. This belt is of recent manufacture. Original belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, formimg highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions. Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the 'lip' or ridge around the underside of the platter, so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installationpage for related details.
15 points will be rewarded to you when you buy this item.