.039 Inch / 1.0mm Thick and Wide; 3.2 Inch / 8.1cm Inside Circumference (total Length).
AIWA CA-70 AIWA HS-JS215 AIWA HS-JS315 AIWA HS-JS415 DUAL C-844 CR-M500 3-5330A LANIER P-100 OLYMPUS S-802 ONKYO TA-2060 RQ-L400 Flywheel 1 RX-F20 CT-4242 CT-F6060 CT-F6262 CT-F7070 CT-F7272 HX-500 B C E SK-21 SK-31 SK-200 SK-210 M-6464 M-CD40 RD-W77 RD-W89 BM-20 HST-59 HST-79 TC-126 CS TC-140 TC-5000 TC-K71 A-650 C-300 K-1020 KX-1200 Meets or exceeds OEM specs. Found in many types of equipment.This belt is of recent manufacture. Original belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, formimg highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the 'lip' or ridge around the underside of the platter,so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installation page for related details.