.039 Inch / 1.0mm Thick and Wide; 9.3 Inch / 23.6cm Inside Circumference (total Length).
Found in many types of equipment.This belt is found in but NOT limited to:
YORK M-2500 AIWA HS-TA317 AIWA HS-P25 AIWA HS-P103 AIWA HS-P105 AIWA HS-P107 AIWA HS-T28MK3 AIWA HS-TA314W AIWA HS-TA317W AIWA HS-TA323 AIWA HS-TX410 AIWA HS-TX446 AIWA HS-TX510 AIWA HS-TX610 AIWA HS-TX646 AIWA HS-TX647 AIWA HS-TX710 CR-W680 CR-W780 CR-W780A CR-W911 CR-W912 CR-W913 CR-W914 PH-D800 PH-D9000 PH-D9900 Deck 2 PH-W3300 PB 3-5638A D-410 TRK-8430H RS-612US RS-676US SG-H10 QUASAR CS-9 SANSUI D-900WR SANSUI D-950WR SANSUI D-1100WR M-7030 M-9703 M-9709 TOSHIBA KT-4059 TOSHIBA KT-4538 TOSHIBA KT-4546 TOSHIBA KT-4549 TOSHIBA KT-V945 TOSHIBA KT-V950 UNIC RV-270 Meets or exceeds OEM specs. Found in many types of equipment. This belt is of recent manufacture. Original belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, formimg highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions. Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the 'lip' or ridge around the underside of the platter,so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installationpage for related details.