As pictured above this is what we call a plug-n-spin kit. , you will receive a complete solution that is ready to plug into most "S-shaped" tonearms. You can be up and spinning in seconds. (minor adjustment(s) recommended.)

PLEASE NOTE: By default this item comes preassembled as pictured. But, if you like, we will leave the kit unassembled. Just make a note in the comments window during the checkout process. We understand some folks would rather receive everything factory sealed.

If you have an empty round socket at the end of your tonearm as pictured above then you can just get this complete assembly. It will just plug right in. Once you adjust the tracking force counterweight to make sure there is not too much needle pressure on the record, you are all set. To properly set the tracking pressure, which will minimize wear n tear on both your records and the needle, you may wish to add the Shure tracking force guage, found in 'Related Products' below.

How do I adjust tracking pressure and anti skate?
If you are lucky enough to have these two adjustments here's how: Move tracking force counter weight till needle suspends/hovers above record. then rotate numbers to zero. (this is zero grams pressure on record) then rotate weight AND numbers to recommended tracking pressure for your needle usually 1.5 to 3 grams is average. Then rotate anti skate to be equal. That should get you there. Basically you want the lease amount of needle pressure pushing down on the record as possible without it skipping too much or sounding bad. That will give you the longest life from your needle and records.

NOTE: Anti skate is adjusting side to side pressure WITHIN GROOVE of record. Tracking pressure is how hard the needle is pushing down inside the groove.

Specifications: Audio Technica AT3600 1/2" Mount Cartridge w/needle

Stylus: .7mil Conical Bonded Diamond tip
Cantilever: Alloy round tube
Tracking Force: 1.5 - 3.0grams
Output Level: 4.2mV @ 5cm/sec. @ 1Khz
Frequency Range: 20 - 20Khz
Load Impedance: 47K ohm
Channel Balance: 1.5 dB
Channel Seperation: 20dB @ 1Khz & 15dB @ 10Khz