Note: This Audio Technica cartridge is the best selling cartridge on the planet. Now, we have exclusively improved the final product to you by installing a high quality .3x.7 elliptical diamond needle. This aftermarket needle is much better than the original entry level conical needle that this cartridge normally has. This will provide you with a mid level setup at a great price. At the time of this writing you can get this complete cartridge for just $4 more than the elliptical needle alone!! Remember though we are recommending this product for entry-level digital transfer, this cartridge is also a fine all-around choice for just directly enjoying records.

Presuming all you need is a cartridge and not the complete LP-2-Digital Xfer Kit, then this is thee recommended setup for transferring your LP's to digital without breaking the bank. The significant jump in the quality of this needle vs. the entry-level conical tip rewards you with a much greater surface contact area where the diamond tip touches the record groove. Being thee top of the line needle for this popular cartridge, it will give you the maximum contact with the record groove. This will lift the greatest fidelity from the grooves, into your computer or digital device so that the most information possible is available for further digital processing.


Audio Technica, a quality brand name has made this available as solid entry level replacement. It will get that old turntable up n running quickly. The same cartridge has been sold with and as original equipment across dozens of brands for decades now. Rest assured if a search has brought you here this is the entry level solution for 1/2" mount turntables regardless of the brand. The corrosponding needle that it comes with is our stock # 211-D6, one of our top 3 products.

Because this cartridge is mounted on the the headshell with two vertically mounted screws, side by side, 1/2" apart, it is known as a 1/2" mount cartridge. Other mounting characteristics are that it has 4 exposed wires in the back and is almost never found on a linear tracking turntable.

Notes:
The headshell is the hardware attached to the end of the tonearm that is usually distinguished by the 'handle' that sticks out to the right for lifting the tonearm over to the record from the rest position. If your turntable is linear tracking it means the whole tonearm slides several inches from side to side as opposed to the standard type usually designated 'straight' or 'S shaped' which pivots on a stationary 'hub' assembly at the right rear corner of the turntable. A linear tracking turntable will generally have buttons you must operate to move the tonearm and will almost always be found with a (T4P) Pmount cartridge. (Go back up one category and click on Pmount).

Myth:
Often people think they must have a brand of cartridge that matches their turntable brand. This is totally unecessary and often impossible to achieve these days. In fact, the vast majority of turntable manufacturers, had a third party cartridge manufacturer make the cartridgeon their behalf. Also, cartridge wiring connections usually go straight to your amplifier, receiver or computer thus allowing the turntable to make no directelectrical changes to the cartridge output signal.

Specifications: Audio Technica AT3600 1/2" Mount Cartridge w/needle

Stylus: .3 x.7mil Conical Bonded Diamond tip
Cantilever: Alloy round tube
Tracking Force: 1.25 - 2.5 grams
Output Level: 4.2mV @ 5cm/sec. @ 1Khz
Frequency Range: 20 - 20Khz
Load Impedance: 47K ohm
Channel Balance: 1.5 dB
Channel Seperation: 20dB @ 1Khz & 15dB @ 10Khz