Turntable to computer, Amp/Receiver.

Grado PH-1D Pre-amp

Grado PH-1 preamp


Below is from the Grado website. We recommend you choose usps priority mail with this order for maximum shipping protection.


THE GRADO PHONO PRE-AMPLIFIER
Grado's New Proprietary Phono Equalization
"The Best of Both Worlds"


Our new Grado Phono Preamp, model PH-1, represents the most successful solution to one of the most complex technical challenges in the field of audio that Grado Labs has ever tackled. It can be compared to the undertaking of designing our highly acclaimed phono cartridges, headphones and our world renowned RA-1 headphone amplifier over the past several years. Our design goals were for a truly superb sounding phono preamp to work equally well with both low and high output cartridges with negligible noise. We wanted a phono preamp with ultra wide band pass, high overload, virtually perfect RIAA amplitude and phase coherency, and very low output impedance. This was the challenge set forth! This we have accomplished!

We realized immediately that a challenge like this was not going to be met by using either of the time-honored methods of passive or active equalization circuits. The relative advantages and disadvantages of these old methods are very well known: the passive preamp approach is characterized by problems of first stage headroom and second stage noise. This is due to the 40dB high frequency insertion-loss of the passive network itself. Phono stage gain is frequency dependent with the result of too little feedback at the low end and too much at the high end. Of course, both extremes are sonically non-optimum and unacceptable.

The more commonly used active equalization stage provides solutions to the classic passive circuit problems, but it also comes with a whole new set of its own problems. These difficulties arise out of the subtle ramifications of the classic negative feedback theory. The RIAA characteristic requires that the amplifier's closed-loop gain needs to change by a hundred to one (40dB) over the entire audio range. This means too little feedback-closure at low frequencies and too much at high frequencies. Too little causes inadequate suppression of simple distortions, and too much causes the generation of complex distortions (high-order).

The new Grado phono preamp circuit design now has all of the advantages of the old methods, yet none of its antiquated disadvantages! The challenge was met! The processing problem has been split into two separate parts: a forward propagating signal current and a back propagating error voltage. We have indeed eliminated all of the past methods. Our new phono equalization technique is a derivative of the principals that we used in our highly regarded RA-1 headphone amplifier. In this design, feedback closure ratio does not change with frequency, but the total output gain does. Virtually all latter stage noise disappears! The output impedance is very low, with the EQ stage opened-loop and the closed-loop gain being the same. The best of both worlds!

What is so significant about these new innovations is the fact that the technical superiority claims absolutely correlate to an unprecedented improvement in openness, greater depth of field and increased definition to the sound of each musical instrument. The PH-1 offers a true freedom from past sonic problems along with Grado's usual warm, smooth, full bodied, non-fatiguing and rich sound qualities that everyone has embraced.

If your turntable is driven with a Grado cartridge then you deserve to go the final step with the new PH-1 phono preamp.



GRADO'S PH-1 PHONO AMP

PART I

Todd Green
"The Vinyl Junkie"

Sales Manager

HeadRoom Corp.

I feel very fortunate to be a part of the preliminary listening group for the new Grado Phono Stage. The wooden box that houses the electronics looked very familiar - it is the same as the box for the RA-1 headphone amp. Not one to care about looks as much as sound; the PH-1 in its pre-production form has all the possibilities of being a good-looking unit. More importantly it sounds fantastic. It has 2 gain settings; the lower of the two fit my Rega Planar 11 with a Grado Reference Sonata cartridge best. The first thing I noticed was how relaxed yet detailed the sound was. Instruments were alive and full - sounding convincingly real. Soundstage was full and accurate. It did not hide flaws but allowed those albums that were produced better to stand out. Each instrument had its place and yet the whole sound remained coherent. Detail was very good with tight deep bass complimenting the sweet mids and smooth highs. It reminded me of why I kept my vinyl and own a turntable - they can sound every bit as good as digital reproduction yet have a natural sound that digital sometimes misses. This is the sound I grew up with and love.

The Grado PH-1 had plenty of gain and when I switched it to high gain it was far too much for my setup. Thus it spent 98% of its time in my rig with it set at low gain. I hope to audition it further with one of the new Statement series cartridges (low output) from Grado and see just how good the high gain setting works, as well.

I spent two very enjoyable evenings listening to the phono amp and look forward to owning one. The naturalness (is that a real word???) and ease of sound reproduction really was music to my ears. I am very familiar with the phono stage in my Krell pre amp and the Grado blew it away. In comparison the Krell was hard and not nearly as musical.

For those of you with high-end tastes and a bit less of a budget, this will be a steal of a deal. I have long looked for an inexpensive phono amp to add to my system and was always either disappointed by the sound quality or unable to cough up the cash to suit my tastes. My wallet and ears finally agree - and it is small enough that my wife won't even notice that it is there! Maybe she'll hear the difference (no, not a chance) and she won't notice the 5 spot missing from the joint account (right!). What she will have is one happy camper listening over and over again to the music that makes me happy. Thank John Grado for another excellent product!

Todd Green
Sales Manager
Headroom Corp.
www.headphone.com



TROUBLESHOOTING:
Are you getting a 60hz hum when the phono preamp is hooked into your receiver/computer?
  • Make sure it is NOT hooked into a 'PHONO' input. Its output is designed to hook into 'TAPE CD AUX' etc inputs!
  • Make sure your house outlet is grounded properly with a little 3 PRONG plugin tester from radio shack or a hardware store.
  • Make sure you are connecting the third grounding wire coming out of the turntable to the external METAL framework of your receiver or computer or preamp thumbscrew.
  • If you get a loud hum when hookin up only the preamp to your receiver/computer, this does not necessarily indicate a fault in the preamp. Many electronic circuits require something called 'termination' When the inputs of an amp or preamp are 'floating' then the output will reflect this.

For software recommendations please checkout the article.
Where you will also find us recommended under our previous site name of turntablebelts.com
This RCA to 3.5mm plug is what you will need for your computer hookup.
Patchcord between preamp and computer soundcard. $6.00 at your local 'shack' FREE when purchasing preamp from us.

Typical Preamp connection to a computer soundcard. And here it is in action!

We also have a regular 'RCA' to 'RCA' 3ft patch cord to connect the output of the pre-amp to your stereo. If you don't have any additional 'RCA' type stereo patch cords sitting around you may wish to have us send one along with your new preamp. Just $2 will save you some lookin or a trip to the store.

Price: $499.50
Buy Product Online | Visit Store Home
 
Manufactured by Grado

  Related Products


  3.5mm Patch Cord - Connect Preamp to Computer Sound Card.
  RCA to RCA Patch Cord - Connect Preamp to newer Amp/Receiver.
  MM/MC PreAmp - Hi-end Pre-Amp


 Other Items from PRE-AMPS

  Pyle Preamp - Turntable to computer or newer Amp/Receiver, a must have.
  Switch Preamp - Turntable to computer or newer Amp/Receiver, a must have.
  MM/MC PreAmp - Hi-end Pre-Amp
  Grado PH-1 preamp - Turntable to computer, Amp/Receiver.
  Thorens Pre-amp - Turntable to computer or newer Amp/Receiver.
  B Tech MM/MC pre-Amp - Pre Amp for Stereo & Computer
  "RCA" Preamp copy - Turntable to computer or newer Amp/Receiver, a must have.
  3.5mm Patch Cord - Connect Preamp to Computer Sound Card.
  RCA to RCA Patch Cord - Connect Preamp to newer Amp/Receiver.

 

  Return To Shop phonograph needles, turntable belts and phono cartridges at TurntableNeedles.com

 

 

e-commerce software
Ecommerce powered by MonsterCommerce shopping cart.