The wait is over! We are so excited to be the first and only to bring this reproduction part back to market. Made of modern resin, our knob provides a great looking solution to your late model Zenith Micro-Touch's missing knob. Made in Oregon, USA, this resin reproduction knob is now exclusively available here as of 2024!  "Impossible" to find anywhere else; this knob is often lost but is much needed to comfortably rotate your dual tipped needle 180° in order to utilize the other tip. To install this knob, it is simply press-fit straight down on the top of the metal shaft of our needle number "897-" seen below. Note that it has a "half-moon hole and so it it polarized and must be installed straight and true.  You must install it after the needle assembly is on the cartridge.  You will need to support the bottom of the needle on the bottom of the cartridge as you push this knob down onto the tines and flat spot of the top the needle assembly protruding up above the cartridge through the headshell.

Primarily compatible with needle "897-"(Zenith's S68567) below.

also substitutes these other knob part numbers:

Replacement for Zenith part number 46-4457 and more.