CNC Turntable AudioPhile Headshell - Black

NOTE: While this headshell works great, we feel the factory left in a few small nicks here and there. As such, during our initial offering, we are passing a great deal to you.

Features:

• True "audiophile" quality for superior fit function.
• Twelve holes and granulated surfaces for spurious harmonic feedback rejection.  Harmonics travel more easily over smooth surfaces.
• CNC (Computer Numerical Controlled) precisely machined from a single block of "aircraft" grade aluminum. Design improvements may occur without notice.
• Many standard aluminum headshells are die cast aluminum. Design improvements not possible.
• Furukawa of Japan sourced 5N Pure Silver litz wire wireset. Each of the 4 cables assemblies have about seven strands of 0.1mm diameter 99.999+% pure soft annealed silver wires. Twisted for maximum noise rejection.
• Extra long mounting slots for maximum cartridge installation flexibility.
• Headshell lead sockets are gold plated.
• Barrel azimuth factory set at 0°

Generally it will fit any turntable with a 'S' (SME/JEI type)shaped tonearm. It requires an empty socket at the front end of the tonearm.
Your socket must be .300 inches in diameter, have a notch in the top for the headshell alignment pin and have four contact in the socket in a square pattern as well as a rotating locking on the tonearm to hold this headshell in place.

If you have a single set screw on the tonearm that holds a headshell in place, then this is not the headshell for you.