TurntableNeedles.com Website logo
Hello Guest! Login
0 Items / $0

Shopping Cart

0 item(s) in your shopping cart

View/Hide options
This item will Autoship every [recurring_frequency]
Subtotal: $0
Flat Belt, Large 16.3 Inch
Large Flat Drive Belt

Flat Belt, Large 16.3 Inch

Rubber drive belt (band) for consumer electronics.
Oregon USA Stock - 0-24hr Shipping!
  • 2
  • $12.00
  • 3
  • $11.00
  • 4
  • $10.00
  • 5+
  • $10.00

Reward Points

16 points can be awarded to your webstore account (see FAQ).

16.3 Inch Long Large Flat Electronics Drive Belt

Found in but not necessarily limited to:

PIONEER; Centrex RT-1011L
PIONEER; Centrex RT-1020F
PIONEER; Centrex RT-1020L
REALISTIC; Radio Shack; Optimus 42-2964 [LAB-200]
REALISTIC; Radio Shack; Optimus LAB-200 [Cat. 42-2964]

  • Meets or exceeds OEM specs. Found in many types of equipment.
  • Caution: This belt is offered as an alternative to the 'approved' FBS16.3" belt. At a 1/4 inch, this is a w-i-d-e belt, as far as turntable standards go. If the FBS16.3" belt has come up as the right belt for your model, before ordering this wider belt, you may wish to verify that the 'channel' on the brass drive motor pulley is wide enough for a 1/4 inch wide belt. If in doubt, you can always use the FBS16.3 in 'Related Products' below. The FBS series is 1/8". We offer this 1/4" wide FBL16.3 as a longer lasting solution where suitable, as verified by the customer.
  • This belt is of recent manufacture. Original legacy belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. ?Our belts are made using state-of-the-art vulcanization chemistry, forming highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.
  • Prior to installation of your new belt, the belt path should be cleaned. ?Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the hub around the underside of the platter,?so it doesn't contaminate the new belt. ?With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. ?It's amazing how much black contamination comes off from the old belt. ?See our belt installation page for related details.

  • 5 Stars
    Excellent Service and Product
    Location carried all of the belts needed for my service work. Highly recommended
    Reviewed by:  from Nampa. on 9/11/2018
    5 Stars
    Flat belt
    Belt fit well
    Reviewed by:  from Ohio. on 2/23/2020
    5 Stars
    The finding of the belt part 1
    Well made belt. a little to wide and thick to work properly on a Magnavox turntable. but will be use on a future project.
    Reviewed by:  from Porterville. on 7/12/2020

    Related Items:


    Recently Viewed Items

    TurntableNeedles.com logo