Flat Belt, Large 38.8 Inch

Stock#:FBL38.8

Brand:AVCR

Reviews (5)

Rubber drive belt (band) for consumer electronics.

$23.00

Oregon USA Stock - 0-24hr Shipping!

Qty:

DiscountPricing

Discount

Pricing

2 - 5
$19.00
6+
$17.00

23 points can be awarded to your webstore account (see FAQ).

Description
Reviews
Specs

Popularity

38.8 Inch Long Large Flat Electronics Drive Belt

This belt is found in, but NOT necessarily limited to, the following Equipment:

KYOCERA PL-910
MICRO SEIKI RX-1500 MICRO SEIKI RY-1500
SAM S.A.M

See FBM-DB208 below for possible substitute.

Belt is of recent manufacture. Meets or exceeds OEM specs.
Found in many types of equipment.

This belt is of recent manufacture. Original legacy belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, forming highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.

Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the hub around the underside of the platter, so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installation page for related details.

Flat Belt, Large 38.8 Inch

perfect fit for my REK O KUT L 34 belt drive conversion

Helpful? 1 of 1 Found Helpful

Reviewed by: Lynn from CA. on 6/22/2013

Nice

I got these for my SOTA that is rocking a ,35+ y.o. belt. Thicker and less costly than the last one I bought from a dealer in 1984.

Helpful? 1 of 1 Found Helpful

Reviewed by: FuzzTone from Lake Zurich. on 11/17/2021

Great fit

A little wider than OEM, a good thing. TT is a Sota Sapphire.

Helpful?

Reviewed by: Jeff from Philadelphia . on 10/5/2023

belts

happy to learn of the existance of turntable needles when hunting for belts for my Ryocera PL910 turntble... it's a rare beastie. Prompt service and hassle free experience thank you

Helpful?

Reviewed by: cliff from brisbane australia. on 1/19/2024

Belt for Rek-O-Kut S-34H

Needed a replacement belt for my Rek-O-Kut S-34H a model about which there is apparently little information. Spoke with Steven at Turntable needles who is very knowledgeable and we decided to try the 38.8' rubber belt even though the original corded (non-stretch) belt measured 39.5". It is a perfect fit as the stretch in the rubber belt maintains the tension adjustment at midpoint as was the original. The turntable operates perfectly. Turntable needles will be my "go to" source for all items of this nature in the future. I highly recommend them.

Helpful?

Reviewed by: Bronxboy from Connecticut. on 9/3/2021