TurntableNeedles.com Website logo
Hello Guest! Login
0 Items / $0

Shopping Cart

0 item(s) in your shopping cart

View/Hide options
This item will Autoship every [recurring_frequency]
Subtotal: $0
Round Belt, Large 4.5 Inch - subs Dual 232076
Large Round Drive Belt

Round Belt, Large 4.5 Inch - subs Dual 232076

Rubber drive belt (band) for consumer electronics.

*Required* Choose Option

Acknowledged Toothless substitution
Oregon USA Stock - 0-24hr Shipping

Reward Points

8 points can be awarded to your webstore account (see FAQ).

4.5 Inch Long Large Round Electronics Rubber Drive Belt

Off the books toothless economical substitution for Dual's  pitch control toothed gear belt 232 076, 232076, 232-076 Referenced as mechanical drawing item #109 in the following service manuals.  

DUAL 504, CS-504
DUAL 1242, CS-1242
DUAL 1245,  CS-1245
DUAL 1246, CS-1246
DUAL 1249, CS-1249

and as drawing item #127 in the service manual for the DUAL 601, CS-601  This substitution works well because there is very little torque require to adjust the pitch so a toothed belt is overkill.  No modification to the pulley is needed.  The round belt will fit nicely in the pulley channel.

also Found in:

ANSCO [GAF] Anscomatic I Movie Projector
ANSCO [GAF] IN-388 Movie Projector
ANSCO [GAF] Memo 8-80 Movie Projector
BAUER T-1/S Movie Projector
BAUER T-12S Movie Projector
BAUER T-15 Super Movie Projector
BAUER T-30 Movie Projector
ELBA Film Strip Proj Movie Projector
KODAK Chevron 8-10 [Caralux] Movie Projector
RICHMOND 600 Movie Projector
RICHMOND 8mm Projector Movie Projector
TECHNIMATION PSS-5001 Movie Projector

  • Meets or exceeds OEM specs. Found in many types of equipment.
  • This belt is of recent manufacture. Original belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, forming highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.
  • Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the 'lip' or ridge around the underside of the platter, so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our
  • belt installation page for related details.
    • Related Items:


      Recently Viewed Items

      TurntableNeedles.com logo