2.5 Inch Long Medium Square Electronics Rubber Drive Belt

This belt is found in, but NOT limited to, the following Equipment:
• TC-K222ESA Mode TC-K707ES CS-204 TC-RX611S CSA-9950 B
CROWN CDM-10
CROWN CRC-9450F
CROWN CRC-9496
CROWN CTA-4400
CROWN SCP-7000
CROWN SHC-44
CROWN SHC-46F
• TRQ-260A W
MAYFAIR 222
MAYFAIR C75008 65-486A
MIDLAND 65-486 CX-121EU CX-131EU CX-141EU 851-0273 6569 CT-F800 CT-F850 CT-F900 CT-F950 CT-F1250 RCA VS-6050 MCD-950 RD-203A TC-C5 Mode TC-C521 Mode TC-K61 IS TC-K711S TC-K890ES Mode TC-K909ES TC-RX606ES TC-WA9ES ModeDk and 2 TC-WR901ES TCK-222ESL TCK-570 TCK-870ES TCR-X77 ES TCR-X470 TCW-R97ES TCW-R770 TCW-R870 TCW-R875 TENNA R-100C TENNA TC-500C A-835-W C-608 C-609 C-682

Meets or exceeds OEM specs. Found in many types of equipment.

This belt is of recent manufacture. Original legacy belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, forming highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.

Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the hub around the underside of the platter,so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installation page for related details.