7.5 Inch Long Mini-Square Electronics Rubber Drive Belt

• CX-4962 CR-W875 3-5244A 3-5438A 3-5438A-POM 3-5475A 3-5477A 1353650 3-5610A 3-5621A 3-5661A RP-1850 PC-111 PC-XT3 AH-57 AH-81 57 AS-9418 AS-94033701 AS-94103701 AS-94133701 AS-95163701 AS-95173701 AS-F95133701 AZ-8700 FW-20123701 700 AS-640M37 AS-641M37 AS-642M37 AS-9516 AS-9517 N-5631 N-5644 TS-5961 CT-50R MAX-345 MAX-360 MAX-440 PCD-710 PCD-720 RCD-1230 RCD-1300 RCD-1365 RCD-1650 SCM-6550 SCM-6800 SCM-7450 SCM-8300 SANKYO 1900 SANSUI D-99CW SANSUI DA-E90 M-7020 M-7022 STD-1700 SCOTT 671-DM QT-38 FX-507 FX-509 WM-F59 WM-F69 WM-F73 WM-FX503 WM-FX507 WM-FX509 6818 TS-9611701 TECHNICS RS-M7 TOSHIBA KT-4868 TOSHIBA KT-V4568 TOSHIBA PC-G4C TOSHIBA PC-G16 C TOSHIBA RT-8700S TOSHIBA RT-S713D TOSHIBA RT-S723D XTAL XA-905 K-07 K-27 K-220 K-420 YORK M-2676

Meets or exceeds OEM specs. Found in many types of equipment.

This belt is of recent manufacture. Original legacy belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, forming highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.

Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the hub around the underside of the platter,so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installation page for related details.