14.6 Inch Long Small Square Electronics Rubber Drive Belt
Belt is of recent manufacture.
Found in many types of equipment.
This belt is found in but NOT limited to:
ALPINE CK-8000 BM-4000 4750R 8500R
CONCORD F-106 E
CRAIG 2709 CRAIG T-619 PH-W704
GRUNDIG CN-222 ATZ-100 XK-962
JET SOUNDS JS-9535 KCR-2001 KRC-3100
MORSE 445-006 MORSE T-11 MORSE T-107 MORSE TM-2
KD-333 KP-333 6910 TR-77 TR-88 TR-100 FT-222M FT-C28 QT-75 RG-3400 ESR-18 TC-125 CSA UL XR-17 XR-3320 XR-4420 XR-5620 XR-6080 XR-6180
TARGA HT-7001 1570 1580 1980 T-905 T-1440 T-1515-4 through 772 T-T570 T-77257 TS-1400 TX-925 TX-926 308
See "find my player" tool for your specific model.
Meets or exceeds OEM specs. Found in many types of equipment.This belt is of recent manufacture. Original legacy belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, forming highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the hub around the underside of the platter, so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installation page for related details.