Status: Sept 2020 - We are 100% OPEN. Stay safe and enjoy those recordings at home once again.

Transitional Square Drive Belt

| Public Question about this item?
Be the first to ask here.

Square Belt, Transitional 2.3 Inch

Our ID#:SBT2.3

Brand:AVCR

Rubber drive belt (band) for consumer electronics.

$3.50

Oregon USA Stock - 0-24hr Shipping

Qty:

4 points can be awarded to your webstore account (see FAQ).

Description
Reviews
Specs

Popularity

2.3 Inch Long Transitional Square Electronics Rubber Drive Belt

This belt is found in, but NOT necessarily limited to, the following Equipment:

unknown at press time, please email us your model if this belt is correct.

Meets or exceeds OEM specs. Found in many types of equipment.

This belt is of recent manufacture. Original legacy belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, forming highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.

Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the hub around the underside of the platter, so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installation page for related details.