Flat Belt, Small 9.4 Inch for Audio Tape Players etc.

Home>Rubber Drive BELTS>BY SIZE DESCRIPTION>FLAT BELT SMALL > Flat Belt, Small 9.4 Inch for Audio Tape Players etc.
$7.00
Add to Cart
Brand: AVCR
Stock#: FBS9.4
Reward Points: 7
Availability: Oregon USA Stock - 0-24hr Shipping!

Description

9.4 Inch Long Small Flat Electronics Drive Belt


This belt is found in, but NOT necessarily limited to, the following Equipment:

GENERAL ELECTRIC 3-5224B Main Belt
GENERAL ELECTRIC 1221798 Drive

PANASONIC RX-1810
PANASONIC RX-1820
PANASONIC RX-1830
PANASONIC RX-5180 Flywheel
PANASONIC RX-CT810
PANASONIC RX-CT820 Deck 2
PANASONIC RX-CT980
PANASONIC RX-DT401
PANASONIC RX-DT600 MaIn Deck 2
PANASONIC RX-DT670
PANASONIC SA-CH60 Main Dk B
PANASONIC SA-DH30
PANASONIC SA-DH44
PANASONIC SA-DH55
PANASONIC SA-HM32
PANASONIC SC-DH20 Main Deck 2
PANASONIC SC-T080
PANASONIC SC-T090
PANASONIC SG-HM22
QUASAR CR-31
QUASAR GX-500
QUASAR GXD-550 Main Deck 2
QUASAR GXD-700
QUASAR MS-450 Main B
ROYAL SOUND RS-1900
SANYO RD-W41 B
SONY CFM-25
SONY CFM-31
PANASONIC RX-DT650 Main Deck 2
AIWA AD-W20U
CRAIG S-604
CRAIG S-611
CRAIG S-682
DUAL C-812
DUAL C-844
SANSUI D-55M
SANSUI D-99D Capstan Belt
SANYO RD-5250
SANYO RD-5350
SHARP SC-180 Mark II(Two)
SHARP SC-210
SHARP SG-181
SHARP SG-181MKI
SHARP SG-220
TOSHIBA RT-8740S
YAMAHA TC-5115

  • Meets or exceeds OEM specs. Found in many types of equipment.
  • This belt is of recent manufacture. Original legacy belts no longer exist. If they did, they'd be too old to sell in good conscience. As far as we can tell, even if the manufacturer name was stamped on the belt, all belts supplied with original turntables were outsourced to a belt specialist manufacturer, like ours are today. Our belts are made using state-of-the-art vulcanization chemistry, forming highly crosslinked polymetric structures which ensure long-term elastic stability even under the harshest conditions.
  • Prior to installation of your new belt, the belt path should be cleaned. Here in the repair shop we would use common household rubbing alcohol (isopropyl) or a similar solution to clean the old, (often invisible) belt residue from the entire belt path, including the hub around the underside of the platter, so it doesn't contaminate the new belt. With the belt off, we would get the turntable into play condition and hold an alcohol soaked Q-tip on the side of the spinning belt motor pulley. It's amazing how much black contamination comes off from the old belt. See our belt installation page for related details.

      • Related Items:

      Tech-Approved Belt Push/Pull Hook Installation Tool
      $11.75
      Oregon USA Stock - 0-24hr Shipping!
      Details