How do I adjust tracking pressure and anti skate?If you are lucky enough to have these two adjustments, move tracking force counter weight until the needle hovers perfectly balanced above the record. Now rotate the dial with numbers (not the weight itself) to zero. (this is zero grams pressure on record) then rotate weight AND numbers together to the recommended tracking pressure for your needle. Then rotate anti skate to have a setting of equal value. Basically you want the least amount of needle pressure pushing down on the record as possible without it skipping or sounding bad. That will give you the longest life from your needle and records.NOTE: Anti skate is adjusting side to side pressure WITHIN GROOVE of record. Tracking pressure is how hard the needle is pushing down inside the groove.
TECHNICAL DATA
Output voltage at 1000 Hz, 5cm/sec.
4 mV
Channel balance at 1 kHz
1,5 dB
Channel separation at 1 kHz
22 dB
Channel separation at 15 kHz
15 dB
Frequency range
20-27.000 Hz
Frequency response
20-20.000 + 2 / - 3 dB
FIM distortion at recommendedtracking force, DIN 45.542
< 1%
Tracking ability at 315Hz atrecommended tracking force
80 Ãâ€Å¡Ãƒâ€šÃ‚µm
Compliance, dynamic, lateral
30 Ãâ€Å¡Ãƒâ€šÃ‚µm/mN
Stylus type
Nude elliptical
Stylus tip radius
r/R 8/18 Ãâ€Å¡Ãƒâ€šÃ‚µm
Equivalent stylus tip mass
0,4 mg
Tracking force range
1,25-1,75 g (12,5-17,5 mN)
Tracking force, recommended
1,5 g (15 mN)
Tracking angle
20Ãâ€Å¡Ãƒâ€šÃ‚°
Internal impedance, DC resistance
1 kOhm
Internal inductance
600 mH
Recommended load resistance
47 kOhm
Recommended load capacitance
200-500 pF
Cartridge colour, body/stylus
Black/Black
Cartridge weight
5 g
Replacement stylus unit
Stylus 20
