The socket must be .300 inches in diameter, have a notch in the top for the headshell alignment pin and have four contact in the socket in a square pattern as well as a rotating locking on the tonearm to hold this headshell in place. NOT for curved S type tonearms.If you have a single set screw on the tonearm that holds a headshell in place, then this is not the headshell for you.
CNC machined from solid imported wood block. The total weight including the copper wireset leads, fingerlift, and screw on counterweight is about 8 grams compared to about 11 grams on the original AT-LP3 shell listed below.
audio-technica AT-LP3WH turntableaudio-technica AT-LP3BK turntableTEAC TN-300 turntableDENON DP-300F turntableMusic Hall MMF-1.3
audio-technica AT-HS3 headshellTEAC AT-HS3 headshellDENON PCL-310 headshell
